← Vinjari

Inspection, Sampling & Measurement
Imesasishwa 7/10/2026
EN987.0 KB
Bila malipo
▶ Anza kujifunza
Icheze hapa hapa kwenye kivinjari chako — hakuna usakinishaji.
Ingia ili kuhifadhi maendeleo yako kwenye vifaa vyotePata programuKujifunza nje ya mtandao kupo kwenye programu.
Utakachojifunza
- Identify and explain the three inspection points: incoming, in-process, and final/output inspection
- Understand what a hold point is and how an Inspection & Test Plan (ITP) controls quality
- Explain why sampling is used instead of 100% inspection and describe the AQL concept
- Identify common measurement tools and explain why calibration is essential
- Perform a concrete slump test, take concrete cube samples, and check rebar diameter against specifications
- Measure timber and steel sections against specifications and apply quality checks
Kuhusu
A practical guide for Kenyan TVET learners on construction quality control — covering inspection points, sampling basics, and hands-on measurement techniques.
Kilichomo ndani· masomo 15
- 1The Three Inspection Points
- 2Hold Points & ITP
- 3Why We Sample: AQL Basics
- 4Measurement Tools & Calibration (1)
- 5Measurement Tools & Calibration (2)
- 6Worked Examples: Concrete & Rebar (1)
- 7Worked Examples: Concrete & Rebar (2)
- 8Worked Examples: Concrete & Rebar (3)
- 9Worked Examples: Concrete & Rebar (4)
- 10Worked Examples: Concrete & Rebar (5)
- 11Worked Examples: Concrete & Rebar (6)
- 12Worked Example: Timber & Steel Section + Quiz (1)
- 13Worked Example: Timber & Steel Section + Quiz (2)
- 14Worked Example: Timber & Steel Section + Quiz (3)
- 15Reflect: How will you apply what you learned?
Sehemu ya njia hizi
Maoni
Hakuna maoni bado.
Maswali na majadiliano
Ingia ili kuuliza swali au kujibu
Hakuna maswali bado.
